The slide now has a set of OEM sights, just what the owner wanted. Test fit the bushing in the slide to ensure enough material is removed and that it’ll fit. A rotary tool with an abrasive wheel can clean this up, followed by some polishing with an abrasive cloth. The staking tool leaves the bottom of the sight tenon deformed. The top is then tapped with a ball-peen hammer. Note the tool is designed to fit into the slide. The steel tool has a hardened pointed tip that displaces the material, staking the sight in place. To deform the bottom of the tenon on the new front sight, I use a front sight staking tool from Brownells. I hold the front sight in a set of bronze jaws with some paper to prevent damaging it. Genuine factory replacement rear sight for the Colt 1911 government CO2 air pistol. If the tenon doesn’t fit snugly, you have the wrong replacement part. Generally, the replacement front sights either have a wide or narrow tenon. To replace the sight, I place the new part in the hole and make sure it fits. If the relieved areas aren’t large enough, a small rotary tool can be used to enlarge them. These areas allow for the displacement of metal from the front sight to hold it in place. If you look closely at the image above, you’ll note there is a slight chamfer on each side of this hole. With the sight removed, you can inspect the slide and the square hole that accepts the front sight.
Replacement sights for a colt 1911 a1 free#
Alternatively, you could grind the bottom of the sight free and/or tap it loose with a punch from the bottom. I’ve removed 1911 sights a number of different ways, but I’ve found one of the easiest is to grab the sight with the vise and wiggle the slide. When you remove the bushing from the slide and examine the bottom of the front sight, you can see where the original sight was staked in place by deforming the metal at the bottom of the sight. As seen in the picture below comparing the factory and ZRTS springs, the ZRTS springs utilize a thicker wire, which can help your pistol run smoother.
The ZRTS springs are more durable than the factory ones.
Replacement sights for a colt 1911 a1 upgrade#
The customer wanted it removed and replaced with an OEM part. Our replacement Colt Umarex 1911-22 Springs are truly an upgrade to the stock springs. This is an aftermarket front sight that was installed on a Colt Delta Elite. Modifications to a firearm may result in personal injury or death, cause the firearm to not function properly, or malfunction, and cause the firearm to become unsafe. Failure to do so may void warranties and result in an unsafe firearm and may cause injury or death.
and its authors, do not assume any responsibility, directly or indirectly for the safety of the readers attempting to follow any instructions or perform any of the tasks shown, or the use or misuse of any information contained herein, on this website.Īny modifications made to a firearm should be made by a licensed gunsmith. The contents of are produced for informational purposes only and should be performed by competent gunsmiths only. In this post, we’ll look at how you can remove a staked front sight and replace it with a new front sight that is staked in place.
While the front sights on many pistols are friction fit into a dovetail, the front sight on the original 1911 pistols is staked in place.
0 kommentar(er)
